Home > Dodge Dakota > 2000 Dodge Dakota Blower Motor Replacement

2000 Dodge Dakota Blower Motor Replacement

Contents

I have a similar problem with my Dakota Quad cab (2004). Eric Irizarry 15,295 views 1:35 How To Replace A Distributor Cap and Rotor Dodge Dakota - Duration: 25:22. As I was sitting in the jeep checking to see if I had power at the speed switch and some other places, the blower kicked on for about a 1/2 second, ChrisFix 1,283,814 views 6:31 94 Dodge Dakota how to fix heater - Duration: 1:35. navigate here

This feature is not available right now. About Press Copyright Creators Advertise Developers +YouTube Terms Privacy Policy & Safety Send feedback Try something new! Rating is available when the video has been rented. The parts were easy to find at a local NAPA store for just 14.77, and wasn't even all that difficult to remove!

2000 Dodge Dakota Blower Motor Replacement

Reply Ryan 3/8/2016 at 10:44 am Did you ever fix your problem? found this post and all the reply's and it was super helpful! If I replace the module, the fan should work again without the jumper wire??? Good luck! Jerry, can you offer some tips?

I am assuming that your Durango has ATC(Automatic temperature control), if this is the case, it is most likely the blower motor solid state resistor module. I have replaced the resistor and the panel to turn it off and on. I cut the wiring close to the plug and removed the resistor with plug still atached. 2003 Dodge Dakota Blower Motor Fuse Location I have now spliced the wires together (with marettes)and connected everything back together.

One circiut was open. Dodge Dakota Blower Motor Resistor Wiring Harness Loading... Can you help me find one?

The first tap (pin 2) is actually at 0 ohms resistance (pins 1 and 2 are shorted together), giving full voltage to the blower motor.

Tim Salem, MA #17 Jan 26, 2007 Jerry wrote: Had the same problem a few weeks ago. 2004 Dodge Dakota Blower Motor Resistor Wiring Harness ChrisFix 443,218 views 11:17 Replacing a resistor pack in my 95 Dakota - Duration: 17:32. Watch QueueQueueWatch QueueQueue Remove allDisconnect Loading... Reply Steve 8/30/2011 at 8:05 pm I also have an 2003 DAKOTA and am replacing the resistor for the third time as well, 122,000 miles Reply Lynne 3/2/2016 at 9:50 am

Dodge Dakota Blower Motor Resistor Wiring Harness

Brake lights won't effect flasher speed. __________________ 68 Camaro (sold): [email protected] / [email protected] ; 2014 Dragster: [email protected], 2014 2X Champions! It sparked a little as I rotated the switch but mostly kept at low speed until I tried working the connectors with a screwdriver and got it into 3rd. 2000 Dodge Dakota Blower Motor Replacement The type of carnage I found with the connector and resistor signaled me to pull out the blower motor and take a look at it. Dodge Dakota Blower Motor Resistor Problems I was shocked at how easy and cheap it was to replace.

The original appeared to be a card of fibreglass or mica or something, presumably with the resistive elements printed on it, and then painted black. check over here Please try again later. It is just the fan switch not working on any speed. pinballman1 23,739 views 15:21 How to replace a Blower Motor Resistor - Duration: 11:17. 2001 Dodge Dakota Blower Motor Replacement

Hope this helps. A few minutes and $18.00 later I have working A/C again! Judged: 30 2 Reply » Report Abuse Judge it! his comment is here Password Register Forgot Password?

Reply John Gerwin 2/29/2012 at 9:44 pm My fan on my 2002 Dakota started smelling like an electrical burn out on the freeway yesterday. 2002 Dodge Dakota Blower Motor Resistor Connector Advertisement Autoplay When autoplay is enabled, a suggested video will automatically play next. DharTV 4,191 views 10:20 Changing Heater Core in 1999 Dodge Dakota - Duration: 11:24.

Average Guys Garage 38,490 views 13:24 1990 Dodge Dakota Blower Motor, Power Windows Electrical Issue - Duration: 5:09. 20's & 30's Ministry 484 views 5:09 1998-2003 Dodge ram van blower switch

  • The whole problem comes from is that the blower motor is junk.
  • Judged: 6 Reply » Report Abuse Judge it!
  • I went to take apart and found the connector was melted.

I plan to pick up a new part this week just to be safe! Thanks again for the great description and pictures. MaximRecoil View Public Profile Send a private message to MaximRecoil Find all posts by MaximRecoil Page 1 of 3 1 23 > Similar Threads Thread Thread Starter Forum Replies 2000 Dodge Dakota Blower Motor Resistor Location Tell me when this thread is updated: Subscribe Now Add to my Tracker First Prev of 6 Next Last Add your comments below Enter Comments Characters left: 4000 You are currently

Battery Geek 143,358 views 7:45 Durango Engine Removal - Duration: 18:31. To my surprise it now works on all speeds except high. Watch Queue Queue __count__/__total__ Find out whyClose Dodge Dakota: Fan Motor Resistor Jim Kenson SubscribeSubscribedUnsubscribe923923 Loading... http://elliottwaveresearch.com/dodge-dakota/2000-dodge-dakota-turn-signal-relay-location.html Show more Language: English Content location: United States Restricted Mode: Off History Help Loading...

A good mechanic engineer technician can fix this….but you will have to pay…is it worth it?…or just forget using the low setting… Hope this helps…heater air con has been pretty good I just didnt know how to hook up the toggle switch and after reading yours i was more then curious to see if it worked. The new module has continuity with all pins, the resistance to pin 1 from subsequent pins steadily increasing, up to pin 5 which had I think 2 or 3 ohms resistance. NOW, if the connector is melted, burnt, get a new one at the same time.

Douglas Harmer 4,757 views 4:13 Loading more suggestions... I am assuming that your Durango has ATC(Automatic temperature control), if this is the case, it is most likely the blower motor solid state resistor module. Please try again later. See pictures and feature comparisons of the least expensive and most popular scanners.

Comments welcome Category Autos & Vehicles License Standard YouTube License Show more Show less Loading... Share your thoughts with the world Share on Facebook Now Don't show me this message again today. 1989 Dodge Dakota 3.9L, heater/ac blower motor (fan speeds) resistor block. Whats normal for this motor? I got very adept at doing this even while driving (not recommended).

To the fan. I will fix this problem this week by replacing the motor and resistor then sawing off the plastic shell around the resistor pins then cutting off the plug from the wiring Reply Gary Joyce 7/16/2011 at 7:35 am Stumbled on this site while looking to solve the blower problem in hopes there was an easy fix … there was and I thank Thanks for the post by the way though.

If so this video can help. Sign in 14 0 Don't like this video? So when you turn the fan to off…the recirc door closes off the outside air…make a selection, except off…this will open the door to the outside…then disconnect the recirculation door actuator About Press Copyright Creators Advertise Developers +YouTube Terms Privacy Policy & Safety Send feedback Try something new!

Carquest carries the replacement part pictured, about $14. Judged: 47 31 Reply » Report Abuse Judge it! Enter your email to get updates when people reply.